Table of Contents
Advertisement
HP MSM313/MSM323 Deployment Guide
goodbye.html
This is the page tenants will see after they logout. It is a standard HTML page and can be
customized as required.
Configure the APs
A. Configure the wireless network
By default each AP is configured to:
• Automatically select the best operating frequency.
• Create a wireless network named HP ProCurve.
• Act as a DHCP client on its LAN ports.
• Use the service controller as the access controller.
There is no need to change these settings for this scenario.
B. Configure the location-aware group name
Set a unique group name on each AP as follows:
1. Select VSC > Profiles.
2. Click the HP ProCurve profile to edit it.
3. Under General, make sure that the Use HP ProCurve MSM controller checkbox is selected.
4. Under Location aware:
• For AP 1, set Group name to Complex_1.
• For AP 2, set Group name to Complex_2.
• For AP 3, set Group name to Complex_3.
5. Click Save.
C. Configure the connection to the service controller on the APs
Each AP will use the services of the service controller to authenticate user logins. Do the following
on each AP.
1. Select Security > Access controller
2. Set the Access controller shared secret to the same unique value on all APs. For example:
xr2t56. This password will be used by the APs to connect to the service controller when they
send authentication requests.
3. Click Save.
By default the AP is set up to use the default gateway assigned by DHCP as the
Note:
access controller. Do not change this setting.
47
2 Public/guest networks
Advertisement
Table of Contents
