Configure Pri, Pri2 And Dpnss Trunks; Configuring Pri And Pri2 Trunks With Trunk Data Block Data Using Ld 14 - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure an E1/T1 card

Configure PRI, PRI2 and DPNSS trunks

Configuring PRI and PRI2 trunks with Trunk Data Block data using LD 14

describes how to configure the Trunk Data Block data required for PRI and PRI2 trunks.
Configuring PRI and PRI2 trunks with Trunk Data Block data using LD 14
1. Log on to the CS 1000E.
2. To access LD 14, enter:
3. Enter the responses shown in
Reconfiguring existing Dchannels on an NTBK51AA/NTBK51AAE5/NTBK51CAE5 (and
later) on page 99 describes how to change the protocol on an established D-channel using
98 Media Gateway 1000E PRI Gateway Installation and Commissioning
LD 14
trunks (LD 14) on page 98.
Table 30: Trunk Data Block data for PRI and PRI2 trunks (LD 14)
Prompt Response
REQ aaa
TYPE xx
TN l ch
DES PRI
PDCA (1) - 16
PCML A
MU
... ...
RTMB 0-511 1-4000
... ...
MNDN xxx..x
TGAR 0 - (1) - 31
... ...
CLS aaaa
... ...
Comments? infodev@avaya.com
Table 30: Trunk Data Block data for PRI and PRI2
Description
Request (aaa = CHG, NEW)
Trunk data block.
Terminal Number for digital trunks where l=loop,
ch=channel.
Designator field for trunk.
Pad category table number.
Pulse Code Modulation Law. Enter the
appropriate value, based on which companding
law is being used on the system.
A = A-Law MU = Mu-Law
Route number and Member Number.
Range is the same as that for CS 1000E
system.
One seven-digit manual directory number.
Trunk Group Access Restriction.
The default value (1) automatically blocks direct
access.
Class of Service.
on page 98
March 2013