Binding Mode - Konica Minolta 7085 Instruction Manual

4.
Position original(s).
Using platen glass:
Place original FACE DOWN. Start scanning from the first page.
When Dual Page, Non-Image Area Erase, Auto detection mode of Repeat,
or AUTO Layout is selected, keep the RADF open throughout the scanning
procedure.
Using RADF:
Position originals FACE UP.
If the number of originals exceeds 100, divide them into blocks not exceeding 100
sheets and load them from the block with the first page.
See p. 3-2 to p. 3-6 for details on positioning originals.
5.
Press [START] to scan.
Repeat steps 4 and 5 until all originals are scanned.
Memory indicator on the upper right of the Basic Screen allows you to check
the remaining memory.
To delete the scanned data without printing, press [STOP], then touch EXIT
on the confirmation screen to be sure the data is deleted.
Should memory overflow occur frequently, it is recommended that you
contact your service representative to extend the memory capacity in your
machine.
6.
Touch STORE to exit the Store mode.
STORE will return to the normal display.
7.
Press [START].
All the data in memory will be output.
Press [STOP] to suspend the printing job.
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
Copying Using Memory (continued)
Reminder!
HINT
DETAILS
HINT
CAUTION
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-111/211
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-33