Konica Minolta 7085 Instruction Manual page 216

Erasing Outside of the Original (Non-Image Area Erase) (continued)
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original FACE DOWN on the platen glass.
DO NOT CLOSE THE DOCUMENT FEEDER.
Original size should be larger than 10mm x 10mm.
7.
Press [START].
The Non-image area erase has two modes; Rectangle erase mode and
Oblique erase mode. The copier is initially set to select either mode appro-
priate for the original placed on the platen glass (AUTO mode).
Key Operator can specify either mode and the original density level manu-
ally so that the Non-Image Area Erase functions without fail.
See p. 13-54.
Having Any Problem?
This function may perform incorrectly if the lighting in the work place is
directly over the platen glass. In this case, consult your service representa-
tive about an appropriate place for installation.
9-28
HINT
Reminder!
DETAILS: Oblique Erase and Rectangle Erase Modes
Oblique erase mode Rectangle erase mode