Konica Minolta 7085 Instruction Manual page 227

Eliminating Black Copy Marks Along Borders (Frame/Fold Erasure) (continued)
To specify Fold Erasure amount:
• Touch to highlight FOLD, if not highlighted, then use the touch screen keypad or up/
down arrow key to enter the desired erasure amount, from 1 to 99mm in 1mm
increments.
5.
Touch OK.
The Application Selection Screen will be restored.
6.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
7.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
8.
Position original(s) FACE UP in the document feeder or FACE DOWN
on the platen glass.
For details on positioning originals, see p. 3-2 to p. 3-6.
When lowering the document feeder onto thick original (e.g. open book), do
not press it down too hard. Keep the document feeder open, if required.
9.
Press [START].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
HINT
HINT
DETAILS
CAUTION
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
OHP
Interleave
Image Insert
Dual Page
Program Job
Non-Image
Area Erase
Reverse
Image
Repeat
9
Applications
Frame/Fold
Erasure
AUTO
Layout
Full-Image
Area
Image Shift
Reduce &
Shift
Stamp
Overlay
Overlay
Memory
9-39