Konica Minolta 7085 Instruction Manual page 224

Repeating Automatically or Selecting Repeating Times (Repeat:
7.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
8.
Position original.
For AUTO mode original, open the document feeder, then position the original FACE
DOWN on the platen glass.
For 2 Repeat, 4 Repeat or 8 Repeat mode original, RADF is also available.
See the illustration on p. 9-34 for details.
When AUTO mode is selected, Non-Image Area Erase functions automatically.
DO NOT close the document feeder.
9.
Press [START].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
The AUTO mode may not operate properly if the lighting in the work place is
directly over the platen glass. In this case, consult your service representa-
tive about an appropriate place for installation.
9-36
HINT
HINT
Reminder!
CAUTION
DETAILS
AUTO/ Repeat Mode) (continued)