Function Setting - Konica Minolta 7085 Instruction Manual

[4] E.K.C. (Electronic Key Counter) Function Setting (continued)
[3] E.K.C. Function Setting
Use this function to turn EKC On or Off, or to select whether the machine will stop when
the count limit is reached, or if the copier will complete the copy job before stopping
when reaching maximum copy count.
EKC Setting Menu Screen
Procedure
1 Touch [4] E.K.C. function setting on the Key Operator Mode Screen. Enter an 8-digit
EKC master key code, then touch OK to display the EKC Setting Menu Screen.
NOTE:
If an invalid EKC master key code is entered, continue by entering the valid
8-digit code.
2 Touch [3] E.K.C. function setting. The EKC Function Setting Screen will be displayed.
3 Touch EKC On to activate EKC or touch EKC Off to de-activate EKC.
The selected key will be highlighted.
4 Touch Immediately to stop the machine at once when the copy limit is reached.
In this case, copy conditions selected for the current job will be cleared. To continue the
job using the same user password, change the copy limit of the password or clear the
copy count.
Touch After job to stop the machine after the current job is completed, when copy limit
is reached.
Touch Warning to only display a warning message when copy limit is reached.
The selected key will be highlighted.
5 Touch OK to complete the setting and return to the EKC Setting Menu Screen.
6 If other EKC setting changes are required, touch desired key, from [1]~[3].
7 Touch PREVIOUS SCREEN to restore the Key Operator Mode Screen.
8 If no further changes are required, touch PREVIOUS SCREEN to restore the Basic
Screen to perform copying operations.
EKC Function Setting Screen
Key Operator
Mode
System Initial
Setting
Copier Initial
Setting
User Setting
Mode
E.K.C.
Lock/Delete
Job Memory
Paper Type/
Special Size
Panel Contrast/
Key Sound
Key Operator
Data Setting
Weekly
Timer
Control Panel
Adjustment
Tray Auto
Select Setting
Power Save
Setting
Memory
Switch
Machine
Management
List Print
Call Remote
Centre
Side 2 Lens
Adjustment
Finisher
Adjustment
HDD
Management
Scan
Transmission
Non-Image
Area Erase
Timing
Adjustment
Centring
Adjustment
13
Key Operator
Mode
13-21