On The Platen Glass - Konica Minolta 7085 Instruction Manual

Copying Using Special Paper (Multi-Sheet Bypass Tray) (continued)
(1) Touch Input size. The Input Size popup menu will appear.
(2) Touch the vertical size key to highlight it. Use the keypad on the popup menu to
enter the vertical size, or use arrow keys to scroll to that number.
The entered number should fall within the range from the vertical size of the
standard size corresponding to the selected wide size, to a maximum of 314mm.
(3) Similarly, touch the horizontal size key to highlight it, then use the keypad on the
popup menu to enter the horizontal size, or use arrow keys to scroll that number.
The entered number should fall within the range from the horizontal size of the
standard size corresponding to the selected wide size, to a maximum of 459mm.
(4) Touch Select size to return to the Select Size popup menu.
Touch Lead edge or Rear edge to select the image starting position.
6.
Touch OK to return to the Basic Screen.
7.
Select additional copy conditions, as desired.
• See p. 8-12 to p. 8-13 for details on copying non-standard size or tab
paper originals.
• See p. 9-16 to p. 9-17 for details on copying onto OHP films.
8.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
9.
Position original(s) FACE UP in the document feeder or FACE DOWN

on the platen glass.

See p. 3-2 to p. 3-6 for details on positioning originals.
10.
Press [START].
HINTS
HINT
HINT
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-111/211
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-31