Manually - Konica Minolta 7085 Instruction Manual

Programmed Shut-Off (Weekly Timer) (continued)
The Timer Interrupt password is not factory set and must be entered by the Key Oper-
ator.
In the event the Timer Interrupt password has not been entered by the Key Operator,
the following message will display instead.
Input copy time
0 hour(s)
When the above message displays, proceed to step 4.
2.
Enter the password.
Enter a 4-digit number Timer Interrupt password using the keypad on the control
panel.
For setting the Timer Interrupt password, see p. 13-35.
If an invalid password is entered, continue by entering the valid 4-digit
password.
3.
Press [START].
The following message will be displayed on the Basic Screen.
Input copy time
0 hour(s)
4.
Set the hour for the interrupt use.
Enter a 1-digit hour (ex. 3 hours is 3) using the keypad on the control panel. (0 ~ 9)
5.
Press [START].
6.
Set the minute for the interrupt use.
Enter a 2-digit minute (ex. 7 minutes is 07) using the keypad on the control panel. (00
~ 59)
Entering a number smaller than 5 will set the minute at 5.
7.
Press [START].
Copying is available until the set time is up.
8.
When Timer Interrupt of the copier is finished, press [POWER SAVER
ON/OFF] for one second or longer, then release it.
The copier returns to the OFF condition and copying is again disabled.
05 minute(s)
HINT
DETAILS
05 minute(s)
DETAILS
Weekly
Timer
Rotation
Vertical/Hori-
zontal Zoom
Fold /
Stitch&Fold
Punch
Z-Fold
Trimming
Cover Sheet
Feeding
Using Finisher

Manually

Tandem Mode
7
A dvanced
Information
7-3