Full-Image; On The Platen Glass - Konica Minolta 7085 Instruction Manual

Copying Image in the Centre of Copy Paper (AUTO Layout) (continued)
4.
Select the desired magnification and paper size on the Basic Screen.
• APS and AMS are automatically released, and 1.00 (100%) is selected
as a magnification ratio.
• Copy mode is automatically set to 1 1. When selecting 1 2 mode,
Platen store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original(s) FACE UP in the document feeder or FACE DOWN

on the platen glass.

For details on positioning originals, see p. 3-2 to p. 3-6.
DO NOT close the RADF when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [START].
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if the lighting in the work
place is directly over the platen glass. In this case, consult your service rep-
resentative about an appropriate place for installation.
DETAILS
HINT
HINT
Reminder!
CAUTION
Having Any Problem?
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
OHP
Interleave
Image Insert
Dual Page
Program Job
Non-Image
Area Erase
Reverse
Image
Repeat
9
Applications
Frame/Fold
Erasure
AUTO
Layout

Full-Image

Area
Image Shift
Reduce &
Shift
Stamp
Overlay
Overlay
Memory
9-41