Konica Minolta 7085 Instruction Manual page 81

Making Double-Sided Copies (1 2, 2 2) (continued)
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position originals FACE UP in the document feeder according to the
original direction specified in step 2.
• See p. 3-2 to p. 3-6 for details on positioning originals.
• Use RADF store mode (p. 3-32 to p. 3-33) when the original count
exceeds 100.
7.
Press [START].
The machine starts to scan originals, then prints duplex copies when ready for output.
Press [STOP] to suspend the scanning or printing job.
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
HINT
HINTS
CAUTION
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-111/211
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-23