PCI Access Cover
T
o install or remove a non-hot-swa
ac
cess cover when you work with hot-swap PCI slot.
R
em
oval
1.
See the
section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from
3.
Re ove the rear access cover.
m
4.
Lo sen the screw securing the PCI access cov
o
5.
Hold the end of the cover (the end where t
Installation
Take the following steps to install the
1.
Orient the PCI access cover
2.
Insert the tab on the rear side of the PCI access cover into the chassis slot.
3.
Slowly and gently put the cover on the chassis, and secure it with a screw.
p PCI board, remove the PCI access cover inside the server. You need not to remove the PCI
the rack.
er.
he screw is loosened), and take out the cover slowly and gently.
PCI access cover.
with the screw toward the front of the server.
9-19