Connecting Peripheral Devices - NEC Express5800 140Rd-4 User Manual

CO NNECTING PERIPHERAL DEVICES
Connect peripheral devices to the server. The server is provided with connectors for wide variety of peripheral devices on its
front and rear. The figure on the next page illustrates available peripheral devices for the server in the standard configuration
and locations of the connectors for the devices.
Observe the following instructions to use the server safely. Failure to follow these instructions may
cause a fire, personal injury, or property damage. See pages 1-3 to 1-8 for details.
Do not connect any interface cable with the power cord of the Express Server plugged to a power
source.
Do not use any unauthorized interface cable.
IMPORTANT:
Power off the server and a peripheral device before connection. Connecting a powered
peripheral dev
USB device).
To connect a third-party peripheral device or interface cable t
service representative for availability of such a device or cable. Some third-party d
not be used for the server.
A leased line cannot be connected directly to the serial port connectors.
Secure the power cord(s) and interface cables with a lock spring.
Form the cables in such a way that they will not come into contact with the door or the guide
rails on the sides of the server.
ice to the powered server will cause malfunctions and failures (excluding the
CAUTION
o the server, consult with your
3-17
evices may