NEC Express5800 140Rd-4 User Manual page 122

4-40
5.
Fix the settings
After settings explained in 4 are completed, select "Accept" in the "Logical Drive X" screen and then press Enter to
fix the settings. When settings are fixed, logical drive display in the "Logical Drive Configured" screen changes from
green (not fixed) to light blue (fixed). The display colour for the drive reveals whether a setting is fixed or not.
To change the determined settings, press Esc to display the "Save Configuration?" screen and select "No." Start over
from "New Configuration."
6.
Save the settings
After fixing the settings in 5, press Esc or Enter. The "Save Configuration?" screen appears.
Select "YES" and press Enter.
After saving is completed, a pop-up window displays a save completion message. Press any key to return to the
"Configure" screen. This completes the SPANNING OF RAID1 logical drive creation procedure.
IMPORTANT:
creation.
Others
1.
Select Adapter.
This menu item appears only if more than one MegaRAID host adapter is installed in the computer. Each
configuration is executed in increments of controller. Number of adapter is defined by PCI slot location.
2.
Clear Configuration.
Clears configuration information.
Select "Configure" → "Clear Configuration" from the TOP menu.
All configuration information on the disk array controller and hard disks is cleared when this function is executed.
Configuration information on all channels of the disk array controller is also cleared with this function.
Be sure to perform "Initialize" and "Check Consistency" after logical drive