NEC Express5800 140Rd-4 User Manual page 274

9-26
Requirements for Hot Add
No boards installed in the s
Verify the available slot according to "List of Optional De
card .
PC I boards installed on the same bus
Prov ide Hot Add for PCI boards operating at the same cloc
Status Lam ps
T wo LED indicators on the back panel indicate the status of the hot-plug PCI add-in boards. You can check the indication by
la mps on the I/O board.
PCI slot Power lamp (green)
Lights when power is supplied normally to the PCI board installed.
PCI slot Fault lamp (amb
Lights when an error occurs on PCI board or the slo
Flas hes when the driver is stopped from Windows Server 2003/Windows 2000 for Hot
Hot Add
Take the following procedure to execute Hot
1.
Pull out the server from the rack
2.
Remove the rear access cover.
3.
Locate the slot in which you are
NO TE:
Confirm that the PCI Slot Power lamp of the slot in which you are going to install the
PCI board is off.
4.
Push the tab at the tip of the additional slot cover of th
the tab. Open the tab.
IMPORTANT:
tab.
ame bus
er)
t containing the PCI board.
Add:
with the power being on.
going to install an additional board.
Do not open the retention tab to 90 degrees or more. Doing
vices and their Available Slots", and then hot-add the PCI
k.
PCI slot Power lamp
PCI slot Fault lamp
e slot in which you are going to install the PCI board to unlock
so could damage the
Remove or Hot Replace.