NEC Express5800 140Rd-4 User Manual page 120

4-38
Setting SPAN
The setting procedure for SPANNING OF RAID1 is shown below.
SPANNING OF RAID1
1.
Open the configuration creation screen.
Select "Configure" → "New Configuration" from the TOP menu to display the screen shown below. This is the
Channel-1 menu screen where the cursor is put on ID=0 position:
2.
Select ID-0/1 hard disks.
Pressing Space changes the display for Channel-1, ID=0 to "ONLIN A01-01" where "A01-01" is blinking. (The
cursor automatically moves to Channel-1, ID=1.) In the same way, press Space on Channel-1, ID=1. (Where
"A01-02" is blinking, the cursor moves to Channel-1, ID=2.) After selecting 2 hard disks (Channel-1,
ID=0/Channel-1, ID=1), press Enter to determine the settings. (Display on each hard disk stops blinking.)