NEC Express5800 140Rd-4 User Manual page 117

IMPORTANT:
Do not set it to "ENABLED."
The virtual sizing function shows the operating system a large disk capacity virtually. Improper
operation thus may disable operating system installation or disk capacity allocation.
13.
Select "Initialize" in the TOP menu screen.
14.
The "Logical Drives" screen appears to select the logical drive to be initialized. Pressing F2 selects all logical drives
displayed.
15.
After selecting logical drive, press F10 to start initialization. A confirmation screen for execution appears. Select
"Yes" to start initialization.
16.
When the meter display in the "Initialize Logical Drive Progress" screen indicates 100%, initialization is completed.
17.
Press Esc to return to the TOP menu and exit MegaRAID Configuration Utility.
Manual rebuilding
Procedures
1.
Replace a hard disk and turn on the controller.
2.
Start MegaRAID Configuration Utility to check each setting parameter.
3.
Select "Rebuild" from the TOP menu to display the "Rebuild – PHYSICAL DRIVES SELECTION MENU" screen
shown below.
4.
Move the cursor onto the hard disk displaying "FAIL," and then press Space to select it.
Be sure to check that «FlexRAID Virtual Sizing" is set to "DISABLED."
Replace hard disk
Start MegaRAID Configuration Utility
Execute rebuilding
Exit MegaRAID Configuration Utility
4-35