NEC Express5800 140Rd-4 User Manual page 299

Installation
T ake the following st eps to install the processor.
IMPORTANT:
T he processor is extremel
t he server to discharge sta
touch the processor pins by a bare hand or place the processor directly on the desk. For static
notes, see the section "Anti-static Measures" described earlier.
When using the server with the single processor configuration, processor must be installed on
the P rocessor #1.
Install the processor in the ascending order of the processor number (see figure above).
T o maintain the cooling effect in the server, install the dummy cover to the empty slot.
1.
See the s ecti n "Preparing for Installation and Removal" described earlier to prepare. o
2.
Unlock t he f ont bezel with the security key, and remove the front bezel. r
3.
Remove the memory slot cover.
4.
Re ove the processor slot cover. m
5.
Re ove the memory board. m
6.
Lo ate the processor socket which you are g c
co er from the socket. v
7.
Remove the protective cover from the socket surface.
8.
Raise the locking lever on the socket.
IMPORTANT:
y sensitive to static electricity. Make sure to touch the metal frame of
tic electricity from your body before handling the processor. Do not
oing to install processor, remove four screws, then remove the dummy
Open the lever until it stops. It can be opened to approx. 120 degre
9-51
es.