NEC Express5800 140Rd-4 User Manual page 158

5-4
Windows Server 2003
Express Setup can install Windows Server 2003 operating system. However, note the following issue:
IMPORTANT:
Before starting the installation, complete all the process of adding the optional device and the
setup of Express server mainframe (BIOS and optional board specification)
A document for installing Windows Server 2003 is also attached to the other software
package which is sold separately, but refer to this document when you install Windows Server
2003 on this model.
After completing Express Setup, see "Setup for Solving Problems" described later to specify
the settings for trouble recovery such as "Specifying Memory Dump".
Installing on the Mirrored Volume
If you want to install Windows Server 2003 on the volume that is mirrored using "Disk Management", invalid the mirroring
before operating the installation to set back to the basic disk, and valid the mirroring again after the installation has completed.
Creating, invalid, delete mirror volume can be operated from "Disk Management" in "Computer Management".
Connecting MO Device
If you operate installing Windows Server 2003 with MO device connected, the installation may not be completed normally. In
such case, disconnect MO device and then re-install the system from the beginning.
Media such as DAT
During the operating system installation, do not connect unnecessary media to the system, such as DAT.
Connecting Hard Disk
Connect the hard disk that operating system is not going to be installed after installing operating system.
NOTE: If you connect the SecuRAID 321 board as a data disk, clear disk array controller's
configuration information before you perform the Express Setup.
The process for clearing configuration information is described in the manual delivered with the
SecuRAID 321 board.