Installing The Front Door; Access Covers; Removing The Rear Access Cover - NEC Express5800 series User Manual

4. Remove the front door.

Installing the Front Door

Note:
To install the front door of the tower cabinet, perform the following procedure.
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Locate the top and bottom hinge slots on the front left-hand side of the
chassis.
3. Grasp the front door and slide its hinge pins into the chassis hinge slots.

Access Covers

This section includes instructions for the following:
!
Removing and installing the rear access cover.
!
Removing and installing the front access cover.

Removing the Rear Access Cover

The rear access cover provides access to the electronics bay, which contains PCI
add-in cards and the server board set, and to the power supply bay. To remove
the cover:
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Release the captive screws located on the rear edge of the cover.
(Figure 4-2, A).
3. While lightly pressing the cover against the chassis, slide it toward the rear
of the chassis.
4. Lift the cover away from the chassis.
Figure 4-2. Removing the Rear Access Cover
4-6 Upgrading Your System
This procedure is for tower-based systems only.
A