Removal Procedure - NEC Express5800 140Rd-4 User Manual

Re mo al Procedure v
More than one person should remove the server from the rack.
Observe the following instructions to use the server safely. Failure to follow these instructions may
result in death or serious personal injury. See pages 1-3 to 1-8 for details.
Do not lift the server only by two or less persons.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
1.
After making sure that the server is off-powered, remove the power cords and all interface cables from the server.
2.
Loosen two screws with which the cable arm is fixed to the rear of the server to remove the cable arm from the
server.
NOTE:
Loosen the screws to unlock the arm stopper.
3.
Release the security lock to remove the front bezel.
Tab
4.
Remove four screws (A) located at both side of the front face of the server.
5.
Hold the handle to pull out the server from the rack slowly and carefully.
The server clicks to be latched.
Cable arm
Frame
2
CAUTION
Screws
1
Unlock Lock
3-15