NEC Express5800 140Rd-4 User Manual page 241

Specified to join the Domain, but the system is installed as Workgroup.
• →
Workgroup. Open [System] in Control Panel to specify joining the Domain.
Specified large value as partition size, but when Windows 2000 is actually started, the system partition is created by
4095MB.
• →
partition in all area of the hard disk (excluding the maintenance area) to install the operating system, specify
[All Area].
Windows 2000 started with different display resolution from the specified value.
• →
default value of the driver.
Entered the incorrect Product ID/CD key.
• →
setup will stop and asks you to re-enter the correct value. Also in this case, input request will occur when
rebooting after GUI setup completed during Express Setup. If these 2 inputs are done correctly, there is no
problem on Windows 2000 setup.
Unable to specify the details of Network adapter.
• →
Control Panel after starting Windows 2000.
Windows 2000 is started with Network adapter that has not been specified during Express Setup
• →
want to modify the specification, it can be done from Control Panel after starting Windows 2000. Also, the
Network adapter that has been specified during Express Setup but that is not connected will not be setup,
though the protocol will only be installed.
Connected more than two Network adapter and specified different protocol for each adapter, but all the protocols are
specified on either adapter.
• →
The value that can not be specified during Express Setup will all be specified by default value.
When more than two Network adapters are specified, the detailed specification of TCP/IP protocol are all set to use
DHCP.
• →
may all be set by default value. Re-specify the details from Control Panel.
Not more than two Network adapters are connected, but the detailed specification of the protocol are all set by default.
(e.g. Specified IP Address on TCP/IP, but DHCP is specified)
• →
In this case, the situation will be the same as connecting more than two Network adapter, so the detailed
specification of the protocol are all set by default.
Re-specify the details from Control Panel after starting the operating system.
When the setup fails to join the Domain during the installation, it will install the system as
Is the [Partition Size] specified by the value larger than the real area? If you want to create one
If the specified display resolution can not be used, the system will use the nearest value or the
Even if you entered the incorrect Product ID/CD key, Express Setup will start. However, the
In Express Setup, you can not specify the details of Network adapter. Specify them from
Windows 2000 will install the recognized Network adapter specified as default value. If you
It's a design. Each adapter is specified so that all the installed protocols can be used.
When more than two Network adapters are specified, the detailed specification of the protocol
Are you specifying more than two protocols?
8-39