NEC Express5800 140Rd-4 User Manual page 233

→ Refer to the manual that comes with your operating system to check that the keyboard and mouse
•
Is the server in the Secure Mode?
→ In the Secure Mode, the keyboard and mouse are disabled. To release the Secure Mode, enter the
Fail to access (read or write) to the floppy disk:
•
Does the floppy disk drive contain a floppy disk?
→ Insert a floppy disk into the floppy disk drive until it clicks.
•
Is the floppy disk write-protected?
→ Place the write-protect switch on the floppy disk to the "Write-enabled" position.
•
Is the floppy disk formatted?
→ Use a formatted floppy disk or format the floppy disk in the floppy disk drive. Refer to the manual
•
Is BIOS configuration correct?
→ The floppy disk drive may be disabled with the BIOS setup utility of the server. Check the setting with
•
Is the server in the Secure Mode?
→ In the Secure Mode, write access to the floppy disk may be disabled. To release the Secure Mode,
Fail to access to the CD-ROM:
•
Is the CD-ROM properly set in the CD-ROM drive tray?
→ The tray is provided with a holder to secure the CD-ROM. Make sure that the CD-ROM is placed
•
Is the CD-ROM applicable to the server?
→ The CD-ROM for Macintosh is not available for use.
Fail to access to the CD-R disk:
•
Is the mounting surface correct?
→ Take out the CD-R disk from the tray, and then set it again with its labelled surface upward.
•
Is there any soil or crack on CD-R disk?
→ Make sure there is no soil due to fingerprint or others on the disk surface. Also make sure that there is
•
Is the CD-R disk closed?
→ Close the session or set the disk in closed status, and try to read again.
•
Are the CD-R disk and writing software appropriate to the disk drive?
drivers are installed. (These drivers are installed along with the operating system.) Some Operating
systems allow you to change the keyboard and mouse settings. Refer to manual that comes with your
operating system to check that the keyboard and mouse settings are correct.
password specified with the BIOS setup utility.
that comes with the operating system for formatting a floppy disk.
the BIOS setup utility.
<Menus to check:
[Main] - [Legacy Floppy A]
[Security] - [Floppy Write Protect]>
enter the password specified with the BIOS setup utility.
properly in the holder.
no crack on the disk surface. Clean the disk surface if it is soiled.
If read-out still fails, set another disk of which data has been successfully read out to check if the drive
can read the disk.
8-31