Problems With Master Control Menu; Problems With Configuration Diskette Creator - NEC Express5800 140Rd-4 User Manual

Problems with Master Control Menu

The master control menu fails to appear:
•
Is your system Windows NT 4.0 or later, or Windows 95 or later?
→ The Master Control menu is supported by Windows NT 4.0 and Windows 95.
•
Is Shift pressed?
→ Setting the CD-ROM with Shift pressed down cancels the Autorun feature.
•
Is the system in the proper state?
→ The menu may not appear depending on the system registry setting or the timing to set the CD-ROM.

Problems with Configuration Diskette Creator

<Common to Windows 2000>
The bit map of the Configuration Diskette Creator window is not displayed correctly during setting of setup
information. (When the Trekking command is used)
• →
displayed correctly, but the setup information can be displayed correctly.
The Point to Point tunnelling protocol cannot be set.
• →
Panel. In this case, rebooting is not necessary.
The details of a network adapter cannot be set.
• →
2000, and set the details through Control Panel.
In such a case, start the Explorer and run \MC\1ST.EXE in the CD-ROM.
If the specified number of colours is fewer than 256 in the display setting, the bit map is not
The protocol is not supported at present. After installation, set the protocol through Control
Configuration Diskette Creator is unable to set the details of network adapters. Start Windows
8-41