Problems With Expressbuilder - NEC Express5800 140Rd-4 User Manual

Problems with EXPRESSBUILDER

When the server is not booted from the EXPRESSBUILDER CD-ROM, check the following:
•
Did you set the EXPRESSBUILDER during POST and restart the server?
→ If you do not set the EXPRESSBUILDER during POST and restart the server, an error message will
•
Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS setup utility of the server. Use the BIOS setup
•
Is an error message appeared?
→ When an error occurs while the EXPRESSBUILDER is in progress, the following message appears.
Message
This machine is not supported.
NvRAM access error.
Hard disk access error.
The system-specific information does not exist on
the I/O board.
Please restore the backup data or write the data by
using [System Information Management] of the
Off-line Maintenance Utility.
Only the authorized personnel are allowed to do this
operation.
appear or the operating system will boot.
utility to change the boot device order to boot the system from the CD-ROM drive first.
<Menu to check: [Boot]>
After this message appears, check the error and take the appropriate corrective action according to the
message listed in the table below.
This EXPRESSBUILDER version is not designed for this server. Run
the EXPRESSBUILDER on the compliant server.
An access to the non-volatile memory (NvRAM) is not acceptable.
The hard disk is not connected or it is failed.
Check whether the hard disk is correctly connected.
The system-specific information cannot be acquired in the I/O board
exchange and so on.
Cause and Remedy
8-37