Error Messages - NEC Express5800 140Rd-4 User Manual

Error Messages

Message
Update isn't necessary.
Illegal data.
BMC information can't be acquired.
Cannot enter the online mode.
Failed to save the current data.
Cannot enter the update mode.
An error was occurred while data is
being updated.
Termination process failed.
The IPMI Driver not found.
BMC is not supported.
If updating still fails, contact your service representative.
Action
The firmware is in up-to-date state.
The data is not for the target device.
Update the firmware with the data of the target device.
Check if the remote management card is correctly installed.
Update the firmware after making sure that the card is correctly installed.
BMC is possibly in Busy state.
Try again several minutes later.
Install the IPMI driver.
The BMC does not support the update function. Updating by this tool is unavailable.
6-21