NEC Express5800 140Rd-4 User Manual page 302

9-54
Removal
T o remove the pro cessor, prepare the removal referring to steps 1 and 5 in the installation procedure and do the reverse
p rocedure of steps 8 to 12.
IMPORTANT:
D o not remove any processor unless it
T o maintain the cooling ef
s ure o install the dummy cover to the slot where the processor is t
A fter the operation, heat may make the cool seat at the bottom of the heat sink adhere to the
pr ocessor. To remove the heat sink from the processor, first turn the heat sink to the left and
right lightly to make sure that the heat sink can be apart from the processor. Removing the heat
s ink ith it adhering to the processor may cause the processor and/or socket to be damaged. w
Take the following pro cedure if a processor is removed (or replaced).
1.
Start SETUP to select menus "Main" – "Processor Settings" – "Processor Retest" in the order to clear the error
information o n the removed processor (see Chapter 4).
When a processor is replaced, select menus "Main" – "Processor Settings" to
Cache of the additional processor are defined normally (see Chapter 4).
2.
Se ct "Yes" for [Reset Configuration Data] on the Advanced menu. le
Thi s is required to update the hardware configuration information. See C
is failed.
fect in the server, the dummy cover is installed in the empty slot. Be
not installed.
confirm that the ID and L2 and L3
hapter 4 for details.