Windows Server™ 2003 Clean Installation - NEC Express5800 140Rd-4 User Manual

E-4
– Windows® Me/98/95
– Windows NT® 4.0
You can create Windows Server™ 2003 OEM-DISK for EXPRESSBUILDER from [Master Control Menu], if you
have a computer on which the above operating systems operate.
Follow the steps below.
1.
Prepare one 3.5-inch floppy disk.
2.
Run Windows Me/98/95, or Windows 2000, Windows Server 2003, Windows NT 4.0, Windows XP.
3.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
[Master Control Menu] will appear.
4.
Click [Setup] with left mouse button and click [Make OEM-DISK] and then [for Windows Server 2003].
NOTE:
You can do the same operation with the menu appeared by the right-click.
5.
Insert the floppy disk into the floppy disk drive according to the message.
Windows Server™ 2003 OEM-DISK for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
Windows Server™ 2003 Clean Installation
This section explains how to perform a clean installation of Windows Server™ 2003.
1.
Turn on the system power.
2.
Insert the Windows Server™ 2003 CD-ROM into the CD-ROM drive.
3.
Press Ctrl + Alt + Delete to reset the system.
After a bootable operating system has been installed on the hard disk, press Enter while the message "Press any key
to boot from CD..." is displayed at the top of the screen.
If no bootable operating system exists on the hard disk, this step is unnecessary.
The Windows Server™ 2003 setup screen will appear.
If the screen is not displayed, Enter was not pressed properly.
Begin after turning on the system power again.
4.
Press F6 in a few seconds when the window is in either of the following states.
– "Setup is inspecting your computer's hardware configuration ..." is displayed.
– A screen with a solid blue background is displayed.
IMPORTANT: There is no visible indication on screen when F6 has been pressed.
5.
When the following message is displayed, press S.
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage device(s).
The following message is displayed.
6.
Insert the Windows Server™ 2003 OEM-DISK for EXPRESSBUILDER into the floppy disk drive, and press Enter.
Please insert the disk labelled
manufacturer-supplied hardware support disk
into Drive A:
*Press ENTER when ready.