Rear Access Cover - NEC Express5800 140Rd-4 User Manual

9-18

Rear Access Cover

T o install or remove the PCI board, o
ac cess cover.
Observe the following instructions to use the
result in death or serious personal injury. See pages 1-3 to 1-8 for deta s.
Be sure to power off the server before removing the rear access cover.
Removal
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Loosen the captive screws located on the rear of the cover.
4.
Slide the rear access cover toward the rear of the chassis.
5.
Li the cover up and off of the chassis. ft
Captive screw
Installation
IMPORTANT :
parts inside the system.
1.
Position the cover on the chassis so that the cover tabs align with the chassis slots.
2.
While lightly pressing down on the cover, slide it toward the front of the chassis.
3.
Attach the c over to the chassis with the captive screws located on the rear of the cover.
Captive screw
r to change cable connections of internal SCSI cable, you will need to remove the rear
CAUTION
Before installing the rear access
server safely. Failure to foll ow these instructions may
il
cover, check that you have not left tools or loose