Memory Board - NEC Express5800 140Rd-4 User Manual

9-38

Memory Board

T o install or remove the DIM M, remove the memory board first.
O ne memory board is factory-installed in the server. Up to four memory boards (3
T he failing DIMM or memory board can be hot-swapped (replacement with power-on state) if the redundant memory boards
h as been configured. For hot-swap memory board, see "DIMM" described later in this chapter.
Memory board slot #1
(for factory-installed
memory board)
Removal
Remove the memory bo ard as described in the following procedure.
IMPORTA NT:
The memory board is extremely sensitive to static electricity. Make sure to touch the metal
frame of the server to discharge static electricity from your body before handling the memory
board. Do not touch the memory board terminals or on-board parts b
memory board directly on the desk. For static notes, see the section "Anti-static Measures"
described earlier.
T he memory board becom
the power and wait for several minutes before pulling it out.
1.
See the sectio n "Preparing for Installation and Removal" described earlier to prepare.
2.
Unlock the fr ont bezel with the security key, and remove the front bezel.
3.
Remove the t wo screws, and remove
Memory board slot #2 Memory board slot #4
(for additional memory (for additional memory
board) board)
es very hot while being powered. When removing the board, turn off
the memory slot cover at the front of the server.
2GB max.) can be installed in the server.
Memory board slot #3
(for additional memory
board)
y a bare hand or place the