Expressbuilder For Dos-Based With Remote Console - NEC Express5800 140Rd-4 User Manual

EXPRESSBUILDER for DOS-based with Remote Console

This subsection describes the procedures for using EXPRESSBUILDER for DOS-based with remote console.
EXPRESSBUILDER contains the remote console feature that allows the system administrator to set up the server from the
management workstation (management PC) via the network or the server's COM2 (serial) port.
IMPORTANT:
Do not use this feature on any other computer than the server, or on any other server obtained
without the EXPRESSBUILDER. Doing so may cause a failure of the server.
When a keyboard is connected to the server, the remote console feature is disabled. The
EXPRESSBUILDER determines that the server has a console. (Nothing is displayed on the
management PC.)
Starting
The following two methods are available to start the server.
Running EXPRESSBUILDER from the management PC via LAN
Running EXPRESSBUILDER from the management PC via direct connection (COM2)
For the procedure for starting EXPRESSBUILDER for DOS-based with Remote Console, see "DianaScope".
IMPORTANT: Do not change the boot device order in BOOT menu in BIOS SETUP.
EXPRESSBUILDER cannot be used if the CD-ROM drive is not the first device to launch the
system.
To use this feature, you need 3.5-inch floppy disk. Please prepare the floppy disk.
NOTE: The following items of BIOS setup information will be set as shown below.
LAN Controller 1 (10/100): [Enabled]
Serial Port A:
Base I/O address:
Interrupt:
Serial Port B:
Base I/O address:
Interrupt:
Serial Port Address:
Baud Rate:
Flow Control:
Console Type:
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[On-board COM B]
[19.2k]
[CTS/RTS]
[PC ANSI]
6-7