Required Tools; Installation Procedure - NEC Express5800 140Rd-4 User Manual

Required Tools

#2 Phillips screwdriver and flat tip screwdriver are recommended for assembling the rack-mount system.

Installation Procedure

Install the server on the rack in the following procedure.
1.
Define the position (height) at which the server is installed by using templates.
The templates have the same vertical size as the server. Put the templates on
them. The installation positions of the core nuts and slide rail assembly are specified on the templates.
2.
Install the core nuts coming with the rack at the positions defined by the templates.
Install four core nuts (two for each of left and right sides) on the front face of the rack from the inner side. The server
is fixed to the rack with the core nuts, four screws (A), and four washers (A).
Install two core nuts from the inner side of the rear of the rack (at the right side when you face the rear of the rack).
Hang the one clip of a core nut on the proper rectangular hole and insert the other clip into the hole using a flat-tip
driver or a similar tool.
IMPORTANT:
Icons showing the positions at which
core nuts are installed
Template (front)
Install the core nuts so that the clips are located at the top and bottom. If any core
the fron
Template (rea r)
t and rear of the rack to locate
3-7