NEC Express5800 140Rd-4 User Manual page 277

(3) Click the [General] tab to display the property to confirm that the device is normally operated.
* The message in the "property" depends
Hot Remove
Take the follo wing procedure to execute Hot Remove:
1.
Take the following steps to stop the device driver used by the Hot-plug PCI board you want to remove:
IMPORT ANT:
the PCI board) from the operating system. Failure to do so may cause the system to fail.
To stop the device driver from the operating system window:
(1) Open [Add/Remove Hardware] in [Control Panel].
Th e [Add/Remove Hardware Wizard] starts.
(2) Cli ck [Next].
on the location of the PCI board slot.
Before removing a PCI board, be sure to stop the driver of the slot (containing
9-29