Remote Management Function; Default Network Settings; Server Setup - NEC Express5800 140Rd-4 User Manual

4-42

REMOTE MANAGEMENT FUNCTION

Remote Management Function enables your system to monitor the status of power supply unit, fan and temperature of servers
by BMC (Baseboard Management Controller) and a remote KVM (Keyboard, Video, Mouse) console feature by
communicating through a management LAN PORT feature.
NOTE:
The screen which can be displayed by the remote KVM side becomes resolution
1024x768 and less than refresh rate 75Hz.
Since a screen is not displayed by remote PC when a setup beyond this is performed, please set it
as less than this.
Moreover, if many numbers of colours of a screen are set up, an exact colour may be unable to be
displayed by remote PC.
When your server is connected to the network where broadcasting occurs frequently, the
performance about remote control may be affected.

Default Network Settings

When linking the management LAN port at the rear of the server to a network, refer to the following for default settings.
Using a DHCP function, the host name in the case of performing automatic registration to a DNS server turns into
the above-mentioned host name.
Host Name: ARMCXXXXXXXXXXXX,
where the 12Xs are the MAC address of the Management Card.
When you link without a DHCP server, please access the above-mentioned IP address in the local network which can
use a default IP address "192.168.1.1."
NOTE:
For security reasons, change these default settings (Password, an IP address, host name)
by your network environment. See "BMC Configuration" described later for the setting method.

Server Setup

This section explains the contents which must be carried out by the server side, when using a Remote Management Feature.
Initial Setup
To use the Web server feature, change settings as shown below.
Start the EXPRESSBUILDER from the CD-ROM, and select [System Management] → [Set Advanced Remote Management
Card] from the Tools menu.
On the [Set Advanced Remote Management Card], select [Remote Management Console] → [Enabled], and then select
[Register].
IMPORTANT:
Setting Graphics Accelerator Driver
When your server's operating system is Windows
IP Address : 192.168.1.1
User Name : administrator
Password : (None)
Host Name : ARMCXXXXXXXXXXXX
For security, the Web server feature of BMC is disabled at shipment.