NEC Express5800 140Rd-4 User Manual page 273

10.
Reinstall the removed components.
11.
Turn on the power of the server. Then make sure that any error message does not appear in POST.
If n error message appears, write down the message and review th a
12 .
St art the B IOS Setup Utility to set the "Reset Configuration Data" in the "Advanced" menu to "Yes."
Th s is required to update the hardware configuration information. See Chapter 4 for details. i
Rem oval
Remove the b oard in the reverse procedure of the installation.
H ot-plug PCI Board
O n the PCI board slots #6 through #9, you can replace or add a hot-plug PCI b
O nly the 100BASE-TX Adapter, the 100BASE-TX Adapter and the 1000BASE
The PCI hot-plug function includes the following functions:
Hot Add
Use Hot Add to install a Hot
Hot Remove
Use Hot Remove to remove a Hot Plug PCI board while the server is operating.
Hot Replace
Use Hot Replace to replace a Hot Plug PCI board while the server is
IMPORTA NT:
Before removing a PCI board, be sure to stop the driver of the slot (containing the PCI board) from
the operating
to fail.
For Windows Server 2003/Windows 2000 server, do not use a function in inactive state after
executing the
inactive state is restarted.
Use the BIOS Setup utility to set the following before executing the PCI Hot Plug function:
Select [Advanced] → [PCI Configuration] → [Hot-plug PCI Control] → [Reserving memory space
r PHP] → Select memo
fo
*1 The memory capacity appears to be less than the actually installed memory capacity.
T o e ecute the PCI Hot-plug function, be sure to login the system as Administrator. x
The b oard avail
and # 7 or #8 and #9. If a PCI board operating at a different clock rate is subject to the hot addition, the
P CI slot fault lamp goes on and the hot plug cannot be performed correctly. However, restarting the
syste m allows BIOS to ignore the setting value and automatically operate the system with the
optim um setting.
Plug PCI board while the server is operating.
system (Windows Server 2003/Windows 2000). Failure to do so may cause the system
PCI Hot-plug function. The system fails to return to the original state when a function in
ry space for installed board*
able for the hot add varies depending on the clock rate previously set by PCI slots #6
e error message list in Chapter 8.
oard while the server is operating.
-T Adapter support the Hot-plug PCI function.
operating.
1
.
9-25