Error Message During Disk Array Configuration - NEC Express5800 140Rd-4 User Manual

8-40
Changed the giga driver speed from 1000 Mbps to 100 Mbps. But the changed speed is not properly displayed in
Network Details of ESMPRO data viewer (still 1000M bps is indicated):
• →
Setup is interrupted at "Creating a working partition" process during the Express Setup.
•
Did you connect the hard disk drive that operating system is not going to be installed?
→ Disconnect the hard disk drive that operating system is not going to be installed, and perform the

Error Message during Disk Array Configuration

Refer to the manual that comes with the disk array controller for any trouble occurred on disk array in this system.
The operating system cannot be installed:
•
Is configuration of the disk array controller performed?
→ Perform configuration properly by using MegaRAID Configuration Utility.
The operating system cannot be started:
•
Is the BIOS setting for the disk array controller changed?
→ Set it properly by using MegaRAID Configuration Utility.
•
Does POST recognize the disk array controller?
→ Check that the disk array controller is connected correctly and then turn the power ON.
→ When the disk array is connected correctly but is not recognized, it may be faulty. Contact the
Rebuilding cannot be performed:
•
Is the capacity of the hard disk to be rebuilt insufficient?
→ Use a hard disk of the same capacity as the faulty one.
•
Is the RAID configuration RAID0?
→ RAID0 does not have redundancy thus rebuilding cannot be performed. Replace the "DEAD" hard
Auto-rebuild cannot be performed:
•
Is the interval enough when hot swap are executed?
→ Take interval more than 90 seconds when hot swap are executed.
•
Is the BIOS setting for the disk array controller correct?
→ Check the BIOS setting for disk array controller by using MegaRAID Configuration Utility. Select
A hard disk goes into "FAIL" status:
→ Contact the maintenance service agent that you are contracted with or the dealer that you purchased it
It does not affect the operation of LAN driver.
Express Setup.
maintenance service agent that you are contracted with or the dealer that you purchased this controller
from.
disk, create configuration information again, perform initialization and then restore using the backup
data.
"Objects" → "Adapter" → "Auto Rebuild" from the TOP menu.
from.