Installing Windows Server 2003 - NEC Express5800 140Rd-4 User Manual

Installing Windows Server 2003

Express Setup proceeds to the setup by specifying the necessary information on the wizard. You can also save the setup
information created on the wizard in a floppy disk as a setup file.
NOTE: One floppy disk formatted by MS-DOS 1.44 MB is necessary to save the setup
information. Please prepare a floppy disk by yourself before the installation.
Using the same setup file you saved and used before allows you to omit specifying the setup
information on the wizard.
And if you use a floppy disk which is attached to the optional device such as disk array controller
and contains device driver to install optional mass storage driver while processing the Express
Setup, you have to save the setup information in the setup file. Please prepare one empty floppy
disk for setup file in this case, too.
1.
Turn the power of peripheral device on, and then turn on the server.
NOTES:
If you operate installing Windows Server 2003 with MO device connected, the installation
may not be completed normally. In such case, detach MO device and then re-install the
system from the beginning.
Connect the hard disk drive that operating system is not going to be installed after installing
operating system.
If you create multiple logical drives in your system, refer to "Reinstalling the operation
system when multiple logical drives exist" (Appendix E).
2.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
3.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the EXPRESSBUILDER. (You may also turn
off and then on again to reboot the server.)
The system will boot from the CD-ROM and EXPRESSBUILDER starts.
4.
Click [Express Setup].
5.
The message, "Do you want to use the parameter file in order to set up the Express Server or Workstation", will be
displayed.
If you use the setup parameter file, click [Yes] and if you do not use the setup parameter file, click [No].
6.
"Note" will be displayed. Read the instruction carefully and click [Confirm].
7.
Notes and restrictions are displayed.
Read the messages carefully and click [Confirm].
NOTE: If some operating system has been installed on the hard disk already, the message which
asks if you continue the installation appears.
If you wish to continue the installation, click [Continue].
8.
If you select "Yes" at step 5, place a floppy disk into the floppy disk drive mounted on the server.
If not, go on the next step.
NOTE: If you set the floppy disk at this step, do not remove the floppy disk from the server until
the message as removing the floppy disk appears.
5-7