NEC Express5800 140Rd-4 User Manual page 237

The server is not found on the network:
•
Is the LAN cable connected?
→ Make sure to connect the LAN cable to the network port on the rear of the server. Also make sure that
•
Is BIOS configuration correct?
→ The internal LAN controller may be disabled with the BIOS setup utility of the server. Check the
•
Have the protocol and service already configured?
→ Install the distinctive network driver for the server. Make sure that the protocol, such as TCP/IP, and
•
Is the transfer speed correct?
→ Open the network property dialog box in control panel to specify the "Link Speed & Duplex" value
The processor name displayed in [General] tab of [System Property] is not in correct position.
→ There is no problem for operation.
The system displays the message below and fails to log in.
→ In Windows Server 2003, the following message will be displayed if you use the operating system
Unable to update the system:
•
Are you trying to update the system without applying Service Pack or with Service Pack 1, 2, or 3?
→ Without applying Service Pack and applying Service Pack 1, 2, or 3 to this system are not supported.
About System Log when re-starting the system on Windows Server 2003
Type:
Source:
Event ID:
Description: Adapter Intel(R) PRO/100 Network Connection: Adapter Link Down
→ When re-starting the system without connecting the network cable, this log may be found in system
the LAN cable to use conforms to the network interface standard.
setting with the BIOS setup utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Embedded NIC 1], [Embedded NIC 2]>
services are properly specified.
the same as the value specified for HUB.
without executing the license authentication. Select "Yes", and execute the procedure for license
authentication.
This copy of Windows must be activated with Microsoft before you can
continue, You cannot log on until you activate Windows.
Do you want to activate Windows now?
To shut down the computer, click Cancel.
You have to apply Service Pack 4 to update the system.
If you use Windows 2000 CD-ROM which includes Service Pack 4 to install Windows 2000 on your
system, you do not have to apply Service Pack 4 again when you update the system.
Warning
E100B
4
event log.
But this has no effect on the behaviour of LAN driver.
Confirm that the system is connected with the LAN cable properly.
If 100Base LAN port is not utilized, disable 100Base LAN on device manager or disable it on BIOS
configuration. Then, the log will not be registered.
Windows Product Activation
YES NO Cancel
8-35