NEC Express5800 140Rd-4 User Manual page 276

9-28
The insulators are installed between the PCI board slots. They are for protecting the PCI board
a lrea y been installed. Take care not to remove or damage the insulator when installing or d
rem oving the PCI board. If the insulator is taken off, reinstall the insulator in place.
8.
Connect the c ables to the PCI board while firmly holding the PCI board with your hand.
9.
Slowly close the tab to secure the PCI board.
10.
Pr ess the PC I Hot Plug switch. The PCI Slot Power lamp flashes o
NOTES:
If the server runs on Windows Server 2003 or Windows 2000, the operating system
a utomatically re
I f an error occurred in
11.
Reinstall the rear access cover and place the
12.
Take the following steps to check if the ad
(1) Select [Control Panel], [Administrative
start the Device Manager.
(2) Move the cursor to the added board.
cognizes the additionally installed PCI board and installs the driver.
the installed board or slot, the PCI Slot Fault lamp goes on (amber).
server into the rack.
ditionally installed PCI board is recognized and oper
Tools], [Computer Management], and [Device Ma
nce and then, goes on.
ating properly:
nager] in the order to