Installing Scsi Controller Driver (Initio 101 Or Adaptec 29320 - NEC Express5800 140Rd-4 User Manual

E-8
1. Click Start menu, Click [Settings] and Click [Network Connections].
The [Network Connections] dialog box appears.
2. Right-click [Local Area Connection] and click [Properties] from pop-up menu.
2.
Click [Configure].
The property dialog box for network adapter appears.
3.
Click the [Advanced] and specify the [Link Speed & Duplex] value the same as the value specified for HUB.
4.
Click [OK] on the property dialog box for network adapter.
[When PROSet is installed]
1.
The [Intel PROSet] dialog box appears.
* Procedure in the case of the standard start menu
Click Start menu, point to [Control Panel] and click [Intel PROSet].
* Procedure in the case of the classic start menu
1. Click Start menu, point to [Settings] and click [Control Panel].
2. Double-click [Intel(R) PROSet] on the [Control Panel] window.
2.
Click [(Network Adapter Name)] in the list.
3.
Click the [Speed] and specify the [Link Speed & Duplex Settings] value the same as the value specified for HUB.
4.
Click [Apply] and click [OK].
Specify the other network drivers with the same process as above.
Also, add or delete any protocols and services if necessary.
You can operate the process on the property dialog box for local area network which can be appeared from [Network and
Dial-up Connection].
NOTE: We recommend you to add "Network Monitor" at "Adding Services".
"Network Monitor" can monitor frames (or packets) sent or received by a computer on which
"Network Monitor" is installed. This is an effective tool for analyzing network faults.
For information about the installation procedure, see Chapter 6.

Installing SCSI Controller Driver (Initio 101 or Adaptec 29320)

If you use SCSI controller driver (Initio 101 or Adaptec 29320), install it according to the following procedure:
Start [Device Manager] from [Start] menu → [Control Panel] → [Administrative Tools] → [Computer Management].
1.
2.
Double-click the SCSI Controller driver which Device Manager lists as unknown device.
3.
Click [Update Driver].
4.
When the "Update Device Driver Wizard" appears, select "Install from a list or specific location [Advanced]" and
click [Next].
5.
Select "Don't search. I will choose the driver to install" and click [Next].
6.
Click [Have Disk..].
7.
Insert "Windows Server™ 2003 OEM-DISK for EXPRESSBUILDER" into the floppy disk drive, enter "a:\" into
"copy manufacturer's file from:" and click [OK].
8.
Specify the following driver and click [Next].
– [INITIO INI-A10XU2W PCI SCSI Controller](When Initio 101 board is installed.)
– [Adaptec SCSI Card 29320ALP - Ultra320 SCSI](When Adaptec 29320 board is installed.)