Flash Memory Format Command; Formatting (Initializing) Range - Toshiba B-SX4T Series Specification

6.3.19 FLASH MEMORY FORMAT COMMAND

Function Formats (initializes) the flash memory card or flash ROM on the CPU board for storage.
Format [ESC] J1; a (, b) [LF] [NUL]
Term a:
b:
Explanation (1) Only a 4-MB flash memory card can be formatted.
(2) The flash memory card can be roughly divided into the PC save area and the
(3) When using a new flash memory card, the area to be used must be formatted
(4) After the flash memory card is formatted, the remaining memory is the PC save
(5) When the flash memory card is used and the already stored data (PC interface
(6) When the label issue operation is performed after the Flash Memory Format
(7) When storing of writable characters, logos, or PC interface commands is not
Refer to • Bit Map Writable Character Command ([ESC] XD)
• Save Start Command ([ESC] XO)
• Save Terminate Command ([ESC] XP)
Example [ESC] J1; A, 1 [LF] [NUL]

Formatting (initializing) range

A: All area of flash memory
B: PC save area of flash memory
C: Writable character storage area of flash memory
Drive (Omissible. If omitted, flash ROM on the CPU board is selected.)
0: Flash ROM on the CPU board
1: Slot 1 on the PCMCIA board (Option)
2: Slot 2 on the PCMCIA board (Option)
writable character storage area.
separately or at the same time.
(initialized) before the PC interface command is saved or writable characters are
stored.
area (895 Kbytes) and writable character storage area (3147 Kbytes). The
remaining memory is displayed on the LCD.
commands, writable characters, logos) is stored again, memory is consumed with
every storing unless the Flash Memory Format Command ([ESC] J1) is
transmitted.
Command is sent, the image buffer is automatically cleared.
continued, the printer automatically enters the online mode (label issue operation)
after about 10 seconds. In this case, the image buffer is automatically cleared.
They can be formatted (initialized) either
- 195 -
[ESC] J1