Save Start Command ([Esc] Xo) - Toshiba B-SX4T Series Specification

6.3.25 SAVE START COMMAND (For Flash Memory)
Function Declares the start of saving PC interface commands.
(Places the printer in the mode where PC interface commands are written in flash
memory.)
Format [ESC] XO; aa, (Sb, ) c [LF] [NUL]
Term aa: Identification number to be used for saving in flash memory or calling
Sb: Drive in which the PC interface command is stored
c:
Notes (1)
(2)
(3)
Refer to • Save Terminate Command ([ESC] XP)
• Flash Memory Format Command ([ESC] J1)
Examples [ESC] J1; B [LF] [NUL]
[ESC] XO; 01, 0 [LF] [NUL]
[ESC] D0508, 0760, 0468 [LF] [NUL]
[ESC] T20C30 [LF] [NUL]
[ESC] C [LF] [NUL]
[ESC] PC001; 0200, 0125, 1, 1, A, 00, B [LF] [NUL]
[ESC] PC002; 0650, 0550, 2, 2, G, 33, B, +0000000001 [LF] [NUL]
[ESC] XP [LF] [NUL]
01 to 99
(Omissible. If omitted, flash ROM on the CPU board is selected.)
b: Drive
0: Flash ROM on the CPU board
1: Slot 1 on the PCMCIA board (Option)
2: Slot 2 on the PCMCIA board (Option)
Status response at save time
0: No status response made
1: Status response made
After sending the Save Start Command ([ESC] XO), any command other than the
following will be saved into flash memory without being analyzed.

• Save Start Command ([ESC] XO)

• Save Terminate Command ([ESC] XP)
• Saved Data Call Command ([ESC] XQ, [ESC] XT)
• Bit Map Writable Character Command ([ESC] XD, [ESC] XA)
• Reset Command ([ESC] WR)
• Status Request Command ([ESC] WS)
• Flash Memory Format Command ([ESC] J1)
• ATA Card Format Command ([ESC] JA)
No error check is made for the commands at save time.
Up to 64 KB can be saved per a save.
- 218 -
[ESC] XO