Download  Print this page

Toshiba B-SX4T Series Specification Page 190

B-sx4t series, b-sx5t series external equipment interface specification.
Hide thumbs

Advertisement

Notes
(1)
If a change of label size or type of sensor, feed fine adjustment, cut position fine
adjustment (or strip position fine adjustment) or back feed fine adjustment is
made, one label must be fed to adjust the first print position prior to printing.
(2)
The parameter of the Feed Command is protected in memory (even if the power is
turned off).
(3)
When "status response made" is selected in the Issue Command parameter
setting, a status response is made after the end of feed or when an error occurs.
(4)
For explanation about the process to stop the label at the home position, refer to
the section regarding the Issue Command.
(5)
If no subsequent command is received from the PC for 1 second after the last
label has been fed, the printer automatically performs an approximately 13.7-mm
forward feed when "Automatic forward feed standby" is set to ON in the system
mode. When the Feed Command is received during the forward feed standby,
the printer feeds the label in reverse to the original position, and then ejects it.
* For notes, refer to the section regarding the Issue Command.
Examples
41.0
mm
73.2
mm
15.0 mm
[ESC] D0762, 0820, 0732 [LF] [NUL]
[ESC] AX; +010, +000, +10 [LF] [NUL]
[ESC] T11C30 [LF] [NUL]
[ESC] C [LF] [NUL]
[ESC] PC001; 0150, 0410, 1, 1, A, 00, B [LF] [NUL]
[ESC] RC001; Sample [LF] [NUL]
[ESC] XS; I, 0004, 0011C3001 [LF] [NUL]
S a m p l e
82.0 mm
Paper feed direction
- 186 -
76.2 mm

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: