Copying Data To/From Usb Memory - Toshiba B-EX4T1 Series Owner's Manual

2. PRINTER SETUP
2.6.12 Copying Data to/from
USB Memory
SYSTEM MODE
<10>RFID
<11>RTC
<12>Z-MODE
<13>USB MEMORY
NOTE:
If a file with the same name
already exists in the USB
memory, it will be overwritten.
The USB Memory menu allows copying data from a USB memory to the
printer and saving data from the printer to a USB memory.
USB memory can be used only when an optional RTC & USB Host
Interface Card, B-EX700-RTC-QM-R, is installed.
(1) USB TO PRINTER
This parameter is to copy data from a USB memory to the printer.
• COPIED DATA
• CONFIG FILE
1. When the file selection screen is displayed, choose a file to be copied.
2. The confirmation message is displayed.
3. The data is read from the USB memory. It takes 3 to 5 minutes to
read all information.
(2) PRINTER TO USB
This parameter is to save the firmware (BOOT/MAIN/CG/
KANJI/HTML), storage area information, and parameter settings to a
USB memory.
• ALL
1. The confirmation message is displayed.
2. The data is copied to the USB memory. It takes approx. 40 seconds to
save all information.
A file is automatically created in the USB memory and named in the
following format based on the printer model and saved date.
/ATA0/SYSTEM/B-EX4T1-T1105.DAT
(e.g. B-EX4T Type1, 305 dpi model, November 5)
E2-39
ENGLISH VERSION EO1-33089
Data including firmware (BOOT/MAIN/
CG/KANJI/HTML), storage area information,
and parameter settings
File containing firmware (BOOT/MAIN/
CG/KANJI/HTML)
2.6 Printer Setting