Auto Configuration File; Format; Model Information; Display Message - Toshiba B-EX6T Series Key Operation Specification

12.3 Auto Configuration File

To execute the auto configuration mode, it is required to create the auto configuration file, which is an
exclusive CFG file, in the USB memory in advance.
The auto configuration file is stored in the following path under the name of "AUTO CONFIG.CFG".
/ATA0/SYSTEM/AUTOCONFIG.CFG

12.3.1 Format

Auto configuration file has the following formats.
B-EX6T1-G,0020
B-EX6T1-T C1.0A
/ATA0/SYSTEM/B-EX-BOOT-Vx.x-xx.bin
/ATA0/SYSTEM/B-EX-MAIN-Vx.x-xx.bin
/ATA0/SYSTEM/B-EX-CG-Vx.x-xx.bin

12.3.2 Model Information

Applicable model's information is stored.
The information is comma separated. The first half is the model name (the above example indicates B-EX6T
Type 1 203-dpi model) and the second half is the PC board information.
If the actual printer and this model information do not match, the auto configuration mode will not start.
Description of the model information:
B-EX6T1-T,0020
PC board information
Resolution
G: 203 dpi
T: 305 dpi
Model
B-EX6T1:B-EX6T1-G/T
B-EX4T1:B-EX4T1-G/T

12.3.3 Display Message

A message displayed on the LCD while the printer is in the auto configuration mode.
Word-wrap feature is enabled.
Only characters that can be expressed with ASCII are allowed to be input.

12.3.4 Firmware File to be downloaded

Name of the file to be downloaded
Example
0020: PC board for QM/CN/QQ model
Model information
Display message
Firmware file to be downloaded
Firmware file to be downloaded
Firmware file to be downloaded
157
Description