Toshiba B-SX4T Series Specification page 279

B-sx4t series, b-sx5t series external equipment interface specification
Hide thumbs Also See for B-SX4T Series:
Table of Contents

Advertisement

LCD Messages of
Upper line
No.
(English)
18
Display of error
command
(See NOTE 1.)
19
POWER FAILURE
20
INITIALIZING...
21
EEPROM ERROR
22
SYSTEM ERROR
23
100BASE LAN
INITIALIZING...
(This is spread over the
upper and lower lines)
24
DHCP CLIENT
INITIALIZING...
(This is spread over the
upper and lower lines)
LED Indication
POWER ON LINE ERROR
- 275 -
Printer Status
A command error has occurred
in analyzing the command.
A momentary power interruption
has occurred.
The memory card is being
initialized.
(Initialization is carried out for
max. of
approximately 15
seconds)
An EEPROM for back-up cannot
be read/written properly.
When any abnormal operations
as below are performed, a
system error occurs.
(a) Command fetch from an odd
address
(b) Access to the word data
from a place other than the
boundary of the word data
(c) Access to the long word
data from a place other than
the boundary of the long
word data
(d) Access to the area of
80000000H to FFFFFFFFH
in the logic space in the user
mode.
(e) Undefined command placed
in other than the delay slot
has been decoded.
(f) Undefined command in the
delay slot has been
decoded.
(g) Command to rewrite the
delay slot has been
decoded.
The 100BASE LAN is being
initialized.
* When the B-9700-LAN-QM
(built-in 10/100BASE Ethernet
interface board) has been
installed.
The DHCP client is being
initialized.
* When the DHCP function is
enabled.
Restoration
Acceptance
by the
of Status
[RESTART]
Request
key
Reset
Yes/No
Command
Yes/No
Yes
Yes
No
No
a
No
No
No
No

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents