Flash Memory Format Command - Toshiba B-EV4 Series Manual

6.3.19 FLASH MEMORY FORMAT COMMAND

Function Formats (initializes) the flash ROM on the CPU board for storage.
Format [ESC] J1; a (, b) [LF] [NUL]
Term a:
b:
Explanation (1) When using a new flash memory, the area to be used must be formatted
(2) When the already stored data (PC interface commands, writable characters, logos)
(3) When a label issue operation is performed after the Flash Memory Format
(4) When storing of writable characters, logos, or PC interface commands is not
Refer to • Bit Map Writable Character Command ([ESC] XD)
• Save Start Command ([ESC] XO)
• Save Terminate Command ([ESC] XP)
Example [ESC] J1; A, 0 [LF] [NUL]
Formatting (initializing) range
A: Entire area of the flash memory (PC save area + writable character area)
B: PC save area of the flash memory
C: Writable character storage area of the flash memory
D: True Type area
Drive (Omissible. When omitted, the flash ROM on the CPU board is selected.)
0: Flash ROM on the CPU board
(initialized) before the PC interface command or writable characters are stored.
is stored again, the memory is consumed every time data is stored, unless the
Flash Memory Format Command ([ESC] J1) is transmitted.
Command is sent, the image buffer is automatically cleared.
continued for about 10 seconds, the printer automatically enters the online mode
(label issue operation). At this time, the image buffer is automatically cleared.
- 145 -
[ESC] J1