Toshiba B-SX4T Series Specification page 245

B-sx4t series, b-sx5t series external equipment interface specification
Hide thumbs Also See for B-SX4T Series:
Table of Contents

Advertisement

oo:
1st byte code of the control code
"00" to "FF" (Specify the hex code in 2 bytes of ASCII code.)
pp:
2nd byte code of the control code
"00" to "FF" (Specify the hex code in 2 bytes of ASCII code.)
qq:
3rd byte code of the control code
"00" to "FF" (Specify the hex code in 2 bytes of ASCII code.)
r:
Peel-off wait status selection
0: OFF (No peel-off wait status selection)
1: ON (Peel-off wait status selection)
s:
[FEED] key function
0: FEED: Feeds one label.
1: PRINT: Prints data of the image buffer on one label.
t:
Kanji code selection
0: TYPE1
1: TYPE2
uu:
Euro code setting
"20" to "FF" (Specify the hex code in 2 bytes of ASCII code)
v:
Automatic head broken dots check
0: OFF (When the power is turned on, the broken dots check is not
automatically performed.)
1: ON
(When the power is turned on, the broken dots check is automatically
performed.)
w:
Centronics ACK/BUSY timing setting
0: TYPE1
1: TYPE2
x:
Web printer function setting
0: OFF (Web printer function is disabled.)
1: ON
(Web printer function is enabled.)
y:
Reset process when the nInit signal is ON
0: OFF (Reset process is not performed.)
1: ON
(Reset process is performed.)
z:
Ribbon near end detection setting
0: Not detected.
1: Detected when the remaining length of the ribbon is 30 m.
2: Detected when the remaining length of the ribbon is 70 m.
A:
Expansion I/O operation mode setting
0: Standard mode
1: In-line mode
B:
Centronics operation mode setting
0: SPP (Compatibility mode)
1: ECP (ECP mode)
(*2)
(*2)
(*2)
- 241 -
(*3)
(*3)
(*3)
(*3)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents