In The Case Of Maxicode Code (Two-Dimensional Code) - Toshiba B-SX4T Series Specification

B-sx4t series, b-sx5t series external equipment interface specification
Hide thumbs Also See for B-SX4T Series:
Table of Contents

Advertisement

In the case of MaxiCode Code (Two-dimensional code)

Format
[ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) [LF] [NUL]
Term
aa:
bbbb:
cccc:
d:
e:
Jffgg:
Zh:
Attachment of Zipper block and Contrast block
Bar code number
00 to 31
Print origin of X-coordinate of the bar code
Fixed as 4 digits (in 0.1 mm units)
Print origin of Y-coordinate of the bar code
4 or 5 digits (in 0.1 mm units)
Type of bar code
Z: MaxiCode (Two-dimensional code)
Mode selection (Omissible)
• When the MaxiCode specification setting is set to "TYPE1: Compatible with
the current version" in the system mode.
Omitted: Mode 2
0:
Mode 2
1:
Mode 4
2:
Mode 2
3:
Mode 3
4:
Mode 4
5:
Mode 2
6:
Mode 6
7:
Mode 2
8:
Mode 2
9:
Mode 2
• When the MaxiCode specification setting is set to "TYPE2: Special
specification" in the system mode.
Omitted: Mode 2 or Mode 3(*)
0:
Mode 2 or Mode 3(*)
1:
Mode 4
2:
Mode 2
3:
Mode 3
4:
Mode 4
5:
Mode 2 or Mode 3 (*)
6:
Mode 6
7:
Mode 2 or Mode 3 (*)
8:
Mode 2 or MODE 3 (*)
9:
Mode 2 or MODE 3 (*)
*: Mode 2 or Mode 3 should be determined depending on the country
code of the data command. When the country code is 840, Mode 2
should be selected. For other codes than 840, Mode 3 should be
selected.
Connection setting (Omissible. No connection if this parameter is omitted.)
ff:
Code number
gg: No. of divided codes
(Omissible. If omitted, they are not attached.)
h= 0: No attachment of Zipper block and Contrast block
1: Attachment of Zipper block and Contrast block
2: Attachment of Zipper block
3: Attachment of Contrast block
- 107 -
01 to 08
01 to 08

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents