No matter what character set or character code is selected, no memory will be
When a new writable character is stored, the Flash Memory Format Command
([ESC] J1) or the ATA Card Format Command ([ESC] JA) must be transmitted.
A character code already stored can be stored in the flash memory card again if
the Bit Map Writable Character Store Command ([ESC] XD) is transmitted, but
memory will be consumed with every storage. Memory can be efficiently used by
sending the Flash Memory Format Command ([ESC] J1) before storing.
If a flash memory card is used, and a label issue operation is performed after
sending the Bit Map Writable Character Command ([ESC] XD), the image buffer is
When the storing operation is not continued after storing the writable character
and logos, the printer automatically enters the online mode (label issue operation)
after about 10 seconds. In this case, when the flash memory card is used, the
image buffer will be cleared automatically.
Only a 4-MB flash memory card manufactured by Maxell can be used for storing a
Flash Memory Format Command ([ESC] J1)
ATA Card Format Command ([ESC] JA)
- 208 -